The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This document describe the steps to install telnet service on Windows servers/ client machine using single command prompt rather than doing it in GUI
Cisco recommends that you have knowledge of these topics:
Windows 7 / 8, Server 2012
The information in this document is based on these software versions:
CloudCenter : 4.8.x
Windows Server 2012
The information in this document was created from the devices in a specific private lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.
Telnet Client is not automatically installed in CloudCenter windows worker VM's when cliqr-tools are installed hence when using telnet client it fails to telnet.
To install telnet client manually, you need to follow below steps.
Step 1. Open a command prompt window. Click Start, type PowerShell in the Start Search box, and then press ENTER.
Step 2. Run install-windowsfeature"telnet-client" from PowerShell as shown in the image.
Step 3. TelnetClient will be installed successfully.
Step 1. Run telnet IP_address Port_number as shown in the image.