Cisco Wide Area Application Services Command Reference 6.4.1x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: October 17, 2018

Chapter: Service Context Configuration Mode Commands

(config-scg) appnav-controller
(config-scg) description

AppNav Controller Group Configuration Mode Commands

To configure an AppNav Controller group (ANCG) that is part of an AppNav Cluster, use the service-insertion appnav-controller-group global configuration command. To unconfigure settings, use the no form of this command.

service-insertion appnav-controller-group ancgroupname { description description | appnav-controller ip-address [ description description ]}

no service-insertion appnav-controller-group ancgroupname { description description | appnav-controller ip-address [ description description ]}

Syntax Description

ancgroupname	Specifies the name of an ANCG to configure and enters AppNav Controller group configuration mode to configure ANCG settings. If the ANCG does not exist, this command creates it.
description description	(Optional) Specifies a description of the ANCG with up to 200 alphanumeric and space characters.
appnav-controller ip-address	Specifies the IP address of an ANC to be added to the ANCG. The address must be the IP address of the interface on which the ANC communicates with other devices in the cluster.
description description	(Optional) Specifies a description of the ANC with up to 200 alphanumeric and space characters.

Defaults

No default behavior or values.

Command Modes

global configuration

Device Modes

appnav-controller

Usage Guidelines

Use the service-insertion appnav-controller-group command to configure an ANCG that is part of a AppNav Cluster. This command initiates the AppNav Controller group configuration mode, which is indicated by a different prompt (config-scg). To return to global configuration mode, enter the exit command.

Each ANC in the AppNav Cluster must be configured with the settings for each ANCG in the cluster by using the service-insertion appnav-controller-group command.

An ANCG can contain a maximum of eight ANCs.

Examples

The following example shows how to configure and enable an ANCG with two ANC members, on an ANC:

ANC(config)# service-insertion appnav-controller-group myControllerGroup

ANC(config-scg)# description AppNav Controller group

ANC(config-scg)# appnav-controller 10.10.8.15 description Primary controller

ANC(config-scg)# appnav-controller 10.10.8.16 description Secondary controller

Related Commands

(config-scg) appnav-controller

(config-scg) description

(config) service-insertion

show service-insertion

(config-scg) appnav-controller

To configure the IP address and description of an ANC to be added to the ANCG, use the appnav-controller AppNav Controller group configuration command. To unconfigure the IP address or description, use the no form of this command.

appnav-controller ip-address [ description description ]

no appnav-controller ip-address [ description description ]