Cisco Nexus 5500 Series NX-OS QoS Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: June 30, 2014

Chapter: W Commands

wrr-queue cos-map

W Commands

This chapter describes the Cisco NX-OS quality of service (QoS) commands that begin with W.

wrr-queue cos-map

To map assigned class of service (CoS) values to select one of the egress queues, use the wrr-queue cos-map command. To return the CoS map to the default setting, use the no form of this command.

wrr-queue cos-map queue-id cos1... cos8

no wrr-queue cos-map queue-id cos1... cos8

Syntax Description

queue-id	ID of the egress queue. The range is from 0 to 3.
cos1... cos8	CoS values that are mapped to select a queue. Enter up to eight CoS values. Separate each value with a space. The range is from 0 to 7.

Command Default

The defaults are as follows:

Receive queue 0 and transmit queue 0: CoS 0 and 1.
Receive queue 1 and transmit queue 1: CoS 2 and 3.
Receive queue 2 and transmit queue 2: CoS 4 and 5.
Receive queue 3 and transmit queue 3: CoS 6 and 7.

Command Modes

Global configuration mode

Command History

Release	Modification
5.2(1)N1(1)	This command was introduced.

Usage Guidelines

Note This command is applicable only to Layer 3 multicast traffic.

You can use this command to distribute traffic into different queues, where each queue is configured with different weighted round robin (WRR) parameters.

You can configure a maximum of four multicast queues for Layer 3 multicast traffic. We recommend that you configure at least one class of service (CoS) value for each multicast queue.