Cisco Nexus 5000 Series NX-OS Unicast Routing Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents
Find Matches in This Book

Results

Updated:
April 10, 2014

Chapter: F Commands

F Commands

This chapter describes the Cisco NX-OS Enhanced Interior Gateway Routing Protocol (EIGRP) commands that begin with F.

feature eigrp

To enable the Enhanced Interior Gateway Protocol (EIGRP), use the feature eigrp command. To disable EIGRP, use the no form of this command.

feature eigrp

no feature eigrp

 
Syntax Description

This command has no arguments or keywords.

 
Command Default

Disabled

 
Command Modes

Global configuration mode

 
Command History

Release
Modified

5.2(1)N1(1)

This command was introduced.

 
Usage Guidelines

You must enable the EIGRP feature before you can configure EIGRP.

Note In Cisco NX-OS Release 5.2(1)N1(1), a software upgrade on the Cisco Nexus 5548 switch and the Cisco Nexus 5596 switch that has the Layer 3 features enabled is disruptive. You must reload the switch and the Cisco Nexus 2000 Series Fabric Extender.

This command requires the LAN Base Services license.

Examples

This example shows how to enable the EIGRP feature:

switch# configure terminal
switch(config)# feature eigrp
switch(config)#
 

This example shows how to disable the EIGRP feature:

switch# configure terminal
switch(config)# no feature eigrp
switch(config)#

 
Related Commands

Command
Description

router eigrp

Creates a EIGRP instance.

show feature

Displays the features enabled on the switch.

show ip eigrp

Displays EIGRP configuration information.

flush-routes (EIGRP)

To flush all EIGRP routes in the unicast RIB when an EIGRP instance restarts, use the flush-routes command. To disable this feature, use the no form of this command.

flush-routes

no flush-routes

 
Syntax Description

This command has no arguments or keywords.

 
Command Default

Disabled

 
Command Modes

Router configuration mode

 
Command History

Release
Modification

5.2(1)N1(1)

This command was introduced.

 
Usage Guidelines

This command requires the LAN Base Services license.

Examples

This example shows how to flush routes when an EIGRP instance restarts:

switch(config)# router eigrp Test1
switch(config-router)# flush-routes
switch(config-router)#
 

 
Related Commands

Command
Description

show ip eigrp interfaces

Displays information about EIGRP interfaces.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco