Cisco Nexus 5000 Series NX-OS Unicast Routing Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

New and Changed
Preface
- A Commands
- B Commands
- C Commands
- E Commands
- F Commands
- I Commands
- L Commands
- M Commands
- N Commands
- P Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- V Commands
- A Commands
- C Commands
- D Commands
- E Commands
- F Commands
- I Commands
- L Commands
- M Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- A Commands
- C Commands
- D Commands
- F Commands
- H Commands
- I Commands
- L Commands
- M Commands
- P Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- V Commands

Find Matches in This Book

Results

Updated:: April 10, 2014

Chapter: M Commands

maximum-paths (RIP)

M Commands

This chapter describes the Cisco NX-OS Routing Information Protocol (RIP) commands that begin with M.

maximum-paths (RIP)

To configure the maximum number of equal cost parallel routes that the Routing Information Protocol (RIP) can install into the routing table, use the maximum-paths command. To remove the maximum-paths command and restore the system to its default condition, use the no form of this command.

maximum-paths maximum

no maximum-paths

Syntax Description

maximum

Maximum number of parallel routes that RIP can install in a routing table. The range is from 1 to 16.

Command Default

8 paths

Command Modes

Router address-family configuration mode

Command History

Release	Modification
5.2(1)N1(1)	This command was introduced.

Examples

This example shows how to allow a maximum of 16 equal cost paths to a destination:

switch(config)# router rip Enterprise

switch(config-router)# address-family ipv4 unicast

switch(config-router-af)# maximum-paths 16

Related Commands

Command	Description
address-family	Enters address-family configuration mode.
copy running-config startup-config	Saves the configuration to the startup configuration file.
show ip rip	Displays a summary of RIP information for all RIP instances.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)