Cisco Nexus 5000 Series NX-OS Unicast Routing Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

New and Changed
Preface
- A Commands
- B Commands
- C Commands
- E Commands
- F Commands
- I Commands
- L Commands
- M Commands
- N Commands
- P Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- V Commands
- A Commands
- C Commands
- D Commands
- E Commands
- F Commands
- I Commands
- L Commands
- M Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- A Commands
- C Commands
- D Commands
- F Commands
- H Commands
- I Commands
- L Commands
- M Commands
- P Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- V Commands

Find Matches in This Book

Results

Updated:: July 1, 2015

Chapter: S Commands

shutdown (VRRP)

S Commands

This chapter describes the Cisco NX-OS Virtual Router Redundancy Protocol (VRRP) commands that begin with S.

shutdown (VRRP)

To disable a Virtual Router Redundancy Protocol (VRRP) configuration, use the shutdown command. To enable a VRRP configuration, use the no form of this command.

shutdown

no shutdown

Syntax Description

This command has no arguments or keywords.

Command Default

Disabled

Command Modes

VRRP configuration mode

Command History

Release	Modification
5.2(1)N1(1)	This command was introduced.

Usage Guidelines

Shut down the virtual router before configuring the virtual router parameters; you can only configure the virtual router after it is in the administrative shut down state. Enter the no shutdown command to update the virtual router state after completing configuration.

Examples

This example shows how to shut down a VRRP group:

switch# configure terminal

switch(config)# interface ethernet 2/3

switch(config-if)# no switchport

switch(config-if)# vrrp 45

switch(config-if-vrrp)# shutdown

switch(config-if-vrrp)# address 6.6.6.45

switch(config-if-vrrp)# no shutdown

switch(config-if-vrrp)#

Related Commands

Command	Description
feature vrrp	Enables VRRP.
show vrrp	Displays VRRP configuration information.
clear vrrp	Clears all the software counters for the specified virtual router.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)