Cisco Small Business SPA100 Series Phone Adapters Administration Guide

Top Panel

Feature	Description
Phone 1 Phone 2	Steady green —On hook. Slow flashing green —Off hook. Off —Port not ready.
Internet	Flashing green —Transmitting or receiving data through the WAN port. Off —No link.
System	Steady green —System ready, IP address acquired. Slow flashing green —Acquiring IP address. (By default, uses DHCP.) Fast flashing green —Upgrading firmware. Off —No power or system can not boot up.

Back Panel

Using the Web-Based Configuration Utility

STEP 1 Connect your computer to the same subnet as the ATA. For example, if the ATA is connected to a LAN port on your router, also connect your computer to a LAN port on your router.

Note: On SPA122, you can connect your computer to the ETHERNET (Yellow) port of the ATA.

STEP 2 Power on your computer.

NOTE: Make sure your computer’s Ethernet adapter is set to obtain an IP address automatically. For more information, refer to the Help for your operating system.

STEP 3 Start a web browser on your computer.

STEP 4 In the Address bar, enter the IP address of the ATA.

• SPA112: Use the ATA’s IVR or your router’s configuration utility to find the dynamically assigned IP address of the ATA. For information about the IVR, see Using the IVR for Administration.
• SPA122: In the Address bar, enter: 192.168.15.1
  Note: 192.168.15.1 is the default local IP address of the ATA.

STEP 5 To log in for the first time, enter the default username, admin, and the default password, admin. The password is case sensitive.

STEP 6 Enter the Connection Type and settings required by your Internet Service Provider. Types include DHCP (the default option), Static IP, and PPPoE (required for most DSL service). After entering these settings, click Submit to establish your Internet connection.

STEP 7 Use the menus to configure your settings, as needed.

Using the IVR for Administration

An IVR system is available to help you to configure and manage your ATA. You can use the telephone keypad to select options and to make your entries.

To access the IVR menu:

STEP 1 Connect an analog phone to the Phone port of the ATA.

STEP 2 Press the star key four times: ****

STEP 3 After the greeting plays, press the keys on the phone keypad to select your options.

STEP 4 Enter the code for the desired action. See the IVR Actions table for details.

TIPS:

• Enter the numbers slowly, listening for the audio confirmation before entering the next number.
• After you select an option, press the # (pound) key.
• To exit the menu, hang up the telephone or enter 3948# to exit.
• After entering a value, such as an IP address, press the # (pound) key to indicate that you have finished your selection. To save the new setting, press 1. To review the new setting, press 2. To re-enter the new setting, press 3. To cancel your entry and return to the main menu, press * (star).
• While entering a value, you can cancel the changes by pressing the * (star) key twice within half a second. Be sure to press the key quickly, or the * will be treated as a decimal point entry.
• If the menu is inactive for more than one minute, the ATA times out. You will need to re-enter the menu by pressing the star key four times: ****. Your settings take effect after you hang up the telephone or exit the IVR. The ATA may reboot at this time.
• To enter the decimal points in an IP address, press the * (star) key. For example, to enter the IP address 191.168.1.105, perform the following tasks:

– Press these keys: 191 * 168 * 1 * 105.

– Press the # (pound) key to indicate that you have finished entering the IP address.

– Press 1 to save the IP address or press the * (star) key to cancel your entry and return to the main menu.