- Preface
- 1 Overview of Access Point Features
- 2 Using the Web-Browser Interface
- 3 Using the Command-Line Interface
- 4 Configuring the Access Point for the First Time
- 5 Administrating the Access Point
- 6 Configuring Radio Settings
- 7 Configuring Multiple SSIDs
- 8 Configuring Spanning Tree Protocol
- 9 Configuring an Access Point as a Local Authenticator
- 10 Configuring WLAN Authentication and Encryption
- 11 Configuring Authentication Types
- 12 Configuring Other Services
- 13 Configuring RADIUS and TACACS+ Servers
- 14 Configuring VLANs
- 15 Configuring QoS
- 16 Configuring Filters
- 17 Configuring CDP
- 18 Configuring SNMP
- 19 Configuring Repeater and Standby Access Points and Workgroup Bridge Mode
- 20 Managing Firmware and Configurations
- 21 Configuring SCEP
- 22 Configuring LLDP
- 23 Configuring L2TPv3 Over UDP/IP
- 24 Configuring Ethernet over GRE
- 25 Configuring System Message Logging
- 26 Troubleshooting
- 27 Miscellaneous AP-Specific Configurations
- APPENDIX A Protocol Filters
- APPENDIX B Supported MIBs
- APPENDIX C Error and Event Messages
Protocol Filters
The tables in this appendix list some of the protocols that you can filter on the access point. In each table, the Protocol column lists the protocol name, the Additional Identifier column lists other names for the same protocol, and the ISO Designator column lists the numeric designator for each protocol.
|
|
|
---|---|---|
|
|
|
---|---|---|
|
|
|
---|---|---|