This command allows the SGSN to associate the RLF template either at
global level which limits the paging messages initiated across both 2G (NSE
level) and 3G (RNC level) access or at per entity level either at RNC level for
3G access or at NSE level for 2G access.
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > SGSN Global Configuration >
Interface Management Configuration
configure > sgsn-global >
interface-management
Entering the above command sequence results in the following prompt:
[local]host_name(config-sgsn-interface-mgmt)#
Syntax
[no] paging-rlf-template {template-name <template-name>} {gb peer-nsei | iu peer-rnc} {name <value> | id <value>}
no
The "No" option removes the association of the rlf-template against
the global level or at particular NSE/RNC.
template-name
<template-name>
Specifies the template name.
gb peer-nsei
id
Maps a specific peer NSE/BSC to the Gb interface by the NSEI.
id
- Enter an integer from 0 to 65535.
gb peer-nsei
name
Identifies a BSC by name assigned to the NSEI, which is stored in the
SCT.
name
- Enter an alphanumeric string of 1 to 64 characters.
iu peer-rnc
id
Maps a specific peer RNC-ID .
id
- Enter an integer from 0 to 65535.
iu peer-rnc
name
Maps a specific peer RNC-Name.
name
- Enter an alphanumeric string of 1 to 64 characters.
Usage Guidelines
This command helps to limit the paging load sent out from the SGSN as
it consumes more bandwidth in the radio interface. The NSE/RNC level
rlf-template association overrides the globally associated rlf-template which
throttles the paging messages initiated from that NSE/RNC with the configured
message rate. The actual RLF template can be configured under the global
configuration mode which provides the option to configure the message-rate,
burst-size, threshold and delay-tolerance for throttling or rate-limiting.
Example
Use the following command to associate a RLF template with name
"rlf1":
paging-rlf-template template-name
rlf1