802.11ax Per WLAN

Information About 802.11ax Mode Per WLAN

Prior to Cisco IOS XE Bengaluru Release 17.4.1, the 802.11ax mode was configured per radio band. In this configuration, the 11ax mode was either enabled or disabled for all WLANs (AP) that were configured per radio, all at once. When 11ax was enabled per radio, the 11ac clients were not able to scan or connect to the SSID if the beacon had 11ax information elements. Client could not probe an access point (AP), if the beacon has 11ax IE.

Therefore, a 11ax configuration knob per AP is introduced, from Cisco IOS XE Bengaluru Release 17.5.1. This knob is introduced under the WLAN profile. By default, the 11ax knob per WLAN is now enabled on the controller.

Configuring 802.11ax Mode Per WLAN (GUI)

Procedure


Step 1

Choose Configuration > Tags & Profiles > WLANs.

Step 2

Click Add.

The Add WLAN window is displayed.

Step 3

Click the Advanced tab.

Step 4

In the 11ax section, check the Enable 11ax check box to enable 802.11ax operation status on the WLAN.

Note

 
When 11ax is disabled, beacons will not display 11ax IE, and all the 11ax features will be operationally disabled on the WLAN.

Step 5

Click Apply to Device.


Configuring 802.11ax Mode Per WLAN (CLI)

Procedure

  Command or Action Purpose

Step 1

configure terminal

Example:

Device# configure terminal

Enters global configuration mode.

Step 2

wlan wlan-profile-name

Example:

Device(config)# wlan wlan-profile

Specifies the WLAN name and enters the WLAN configuration mode.

Step 3

dot11ax

Example:

Device(config-wlan)# dot11ax

Configures 802.11ax on a WLAN.

Step 4

no dot11ax

Example:

Device(config-wlan)# no dot11ax

Disables 802.11ax on the WLAN profile.

Verifying 802.11ax Mode Per WLAN

To display the status of the 11ax parameter, run the following command:

Device# show wlan id 6
WLAN Profile Name     : power
================================================
Identifier                                     : 6
Description                                    :
Network Name (SSID)                            : power
Status                                         : Enabled
Broadcast SSID                                 : Enabled
Advertise-Apname                               : Disabled
Universal AP Admin                             : Disabled
Max Associated Clients per WLAN                : 0
Max Associated Clients per AP per WLAN         : 0
Max Associated Clients per AP Radio per WLAN   : 200
.
.
.
802.11ac MU-MIMO                               : Enabled
802.11ax parameters
    802.11ax Operation Status                  : Enabled
    OFDMA Downlink                             : Enabled
    OFDMA Uplink                               : Enabled
    MU-MIMO Downlink                           : Enabled
    MU-MIMO Uplink                             : Enabled
    BSS Target Wake Up Time                    : Enabled
    BSS Target Wake Up Time Broadcast Support  : Enabled
.
.
.