The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
The gateway can run in either of two power modes:
Main power mode - Power is supplied to all server components and any operating system on your drives can run.
Standby power mode - Power is supplied only to the service processor and certain components. It is safe for the operating system and data to remove power cords from the server in this mode.
 Caution |
After the IEC6400 gateway is shut down to standby power, electric current is still present in the IEC6400 gateway. To completely remove power as directed in some service procedures, you must disconnect all power cords from all power supplies in the server. |
|
Step 1 |
Check the color of the Power button/LED:
|
||
|
Step 2 |
Initiate either a graceful shutdown or a hard shutdown:
|
You must log in with user or admin privileges to perform this task.
|
Step 1 |
In the Cisco IMC home page, click . |
|
Step 2 |
Click OK. |
You must log in with user or admin privileges to perform this task.
|
Step 1 |
Click Launch vKVM in the Cisco IMC interface. |
|
Step 2 |
At the server prompt, enter: |
|
Step 3 |
At the chassis prompt, enter: |
|
Step 4 |
(Optional) You can also directly shut down the gateway using the Power off option in Launch vKVM, click . |
|
Step 5 |
(Optional) Click Confirm. |
Feedback